RV Dish Satellite Stand. Tripod Satellite Dish Stand. Portable Satellite Dish Stand
 

Setting the correct Azimuth is quick & easy. The stand is a compass with a large Azimuth display allowing the dish to be set to the Azimuth location required by the control unit.
With built-in gauges for the Horizontal and Skew/Tilt, these settings can also be set quickly.


Once the dish and the stand have been calibrated the gauges on the dish antenna itself should not be changed.


"PDQ Signal" is made of molded nylon-6 with some parts having glass added to the nylon for addition strength. This allows the stand to be lightweight yet very strong.
It sets close to the ground using weights as a counter balance to the LNB. Using the weighs as a counter balance allows the stand to be very stable, have a smaller footprint and capable of withstanding strong winds.
During strong winds some flexing in the mast will be visible. However, because of the ability to attain a strong signal, picture quality is not normally affected by this flexing.


This is not recommended for the small DirecTV round 101 Satellite antenna. That dish only points at one satellite making it very easy to set up and to locate a good signal. Because of it's light weight and size Delsand LLC recommends a less costly stand, such as a small tripod. However, if you are going to use the round dish from DirecTV with a Delsand LLC stand order the Std with spacer Model . A special spacer must be used for the post to fit the bracket.
This model does not work on the SlimLine HD 5 satellite as this dish requires a post with a larger OD. The 2" OD Model has the post with a larger OD.


Due to the shipping cost the weights are NOT included. Delsand LLC recommends two 5 pound or heaver dumbbells be used, holders for this type of weight is built into the stand. The weights can be purchased at most stores that carry sporting or exercise equipment.

Made in the USA
Patent Pending
Designed and Patented by Delsand LLC in Lake Stevens, WA
Tooling Designed and Made by Ideality Inc. in Stanwood, WA
Injection Molding in Nylon-6 Done in Mukiteo and Everett, WA
Assembled, Boxed and Shipped in Stanwood, WA

Home | Detail Information | View & Purchase Products | Instruction & Info Sheets | About Us
Frequently Asked Questions | Buzz Words | Links | Conditions of Use
Shipping & Returns
Sign In/Out | Privacy Notice | Site Map

Copyright © Delsand LLC
Site Developed by EcomBuffet.com LLC

RV Dish Satellite Stand. Tripod Satellite Dish Stand. Portable Satellite Dish Stand
 

Home

Detail Information

View & Purchase Products

Instruction & Info Sheets

About Us

Frequently Asked Questions

Buzz Words

Links

Conditions of Use

Shipping & Returns

Privacy Notice

Sign In/Out

Contact Us